Get one of these Rhodes Race Cars Elite Series Anti-Roll Bar / Sway Bar Kit's for your ride today. These new anti roll bar kits are available in 24" or 36" lengths. The tubes can be cut down to any desired length before welding in the splined billet shafts to the end of the tubing. This will allow you to install them at any desired width.
Kit comes complete with:
- 2" diameter .250" wall 4130 Tubing.
- 45 Spline Gun Drilled shafts
- 4130 Billet Steel splined arms.
- Self-aligning spherical bearings to eliminate binding.
- Steel Bearing Cups with snap rings for ease of mounting.
- Comes complete with all mounting tabs, rod ends, and Grade 8 hardware.
- Works great on cars up to 3500HP and up to 3200 pounds.
Note: Kit does require welding during installation